Augenfälligstes Merkmal ist die geänderte Bell – Hiller Mischung die nun direkt am Blatthalter sitzt. Allein hier ergeben sich 2 x 2 x 2 = 8 Einstellmöglichkeiten. Außerdem ist es nun auch erstmals möglich die Wirkung der Delta – 3 Rücksteuerung einzustellen.

Der Rotorkopf wird als Bausatz geliefert und bietet folgende Einstellmöglichkeiten:

Adjustment Mounting Holes Introduction:
1. Main Blade Grip Deltas
There are three holes on main blade grips for delta adjustment.  The holes, counting from inside out, represents:  Positive delta, zero delta, and negative delta.  Positive delta produces the effect of increased cyclic speed.  Negative delta has the opposite effect of positive delta, which decreases the cyclic speed.  Zero delta has the average effect of positive and delta, and is the standard setting.

2. Mixing Arm (U) Left Mounting Holes – Bell mix ratio
Mixing Arm (U) has an inner and outer hole on left side (inner hole is near pivot point, outer hole is near blade grips ).  Different hole positions has effect on collective pitch speeds.  Inner hole is used for larger collective range and faster collective response required by 3D pilots; Outer hole results in higher control resolution and toned down collective response, which is beneficial for F3C pilots.

3.Mixing Arm (U) Right Mounting Holes
mixing arm also has an inner and outer hole on right side (inner hole is near pivot point, outer hole is near blade grips).  In this case, different hole positions has effect on flybar effectiveness.  Inner hole increases flybar effectiveness, resulting in higher stability and gust resistance;  Outer hole reduces flybar effectiveness, which increases agility for better 3D performance.

4. Mixing Arm (L)- Hiller mix ratio
Mixing Arm (L) also has two mounting holes (inner hole is near pivot point, outer hole is near blade grips).  Different hole position in this case will have direct effect on cyclic roll/flip rate.  Inner hole results in slower cyclic roll/flips, with softer maneuver execution;  Outer hole makes cyclic roll/flips response faster and more direct, resulting in increased agility for 3D flying.

Bei den Hauptrotorköpfen sind ein Zentralstück, die jeweilige Anzahl von Blatthaltern mit Anlenkgestänge und auch eine Taumelscheibe mit Taumelscheibenmitnehmer enthalten. Die passenden Spinblades Rotorblätter werden zum Ende des Monats erwartet.

[Show as slideshow]

Das Tuningteil kostet derzeit etwa 23EUR (+Versandkosten) und kann hier bezogen werden: www.gforceheli.com